IBM 8669 - Eserver xSeries 342 Hardware Maintenance Manual page 98

Error Code/Symptom
011-XXX-000 (Failed COM1 Serial Port
test)
011-XXX-001 (Failed COM2 Serial Port
test)
014-XXX-000 (Failed Parallel Port test)
015-XXX-001 (USB interface not found,
board damaged)
015-XXX-015 (Failed USB external
loopback test)
015-XXX-198 (USB device connected
during USB test)
020-XXX-000 (Failed PCI Interface test)
020-XXX-001 (Failed Hot-Swap Slot 1 PCI
Latch test)
020-XXX-002 (Failed Hot-Swap Slot 2 PCI
Latch test)
020-XXX-003 (Failed Hot-Swap Slot 3 PCI
Latch test)
020-XXX-004 (Failed Hot-Swap Slot 4 PCI
Latch test)
030-XXX-000 (Failed Internal SCSI
interface test)
035-XXX-099
035-XXX-S99 (Failed RAID test on PCI slot
S, check System Error Log before replacing
a FRU)
035-XXX-SNN (Check System Error Log
before replacing a FRU, NN = SCSI ID of
failing fixed disk)
035-253-S99 (RAID adapter initialization
failure)
075-XXX-000 (Failed Power Supply test)
089-XXX-001 (Failed Microprocessor test)
88
Hardware Maintenance Manual: xSeries 342 Type 8669
FRU/Action
1. System Board
1. System Board
1. System Board
1. System Board
1. Make sure parallel port is not disabled.
2. Re-run USB external loopback test.
3. System board
1. Remove USB devices from USB1 and USB2.
2. Re-run USB external loopback test.
3. System Board
1. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1. PCI Hot-Swap Latch Assembly
2. System Board
1. System Board
1. No adapters were found.
2. If adapter is installed re-check connection.
1. Adapter
2. SCSI Backplane
3. Cable
1. Fixed Disk with SCSI ID NN on RAID adapter in PCI slot S.
1. ServeRAID Adapter in slot S is not configured properly. Obtain
the basic and extended configuration status and refer to the
ServeRAID Hardware Maintenance Manual for more information.
2. Cable
3. SCSI Backplane
4. Adapter
1. Power Supply
1. VRM 1 for Microprocessor 1
2. Microprocessor 1