HP Integrity BL890c - i2 Server Manual page 213

Scenario 3-2 – Cisco IOS command line configuration
(VLAN Tagging (802.1Q) with Multiple Shared Uplink
Sets (SUS))
Connect to the Cisco switch servicing the VC-Enet uplink ports and enter the following IOS commands.
NOTE: If t w o s w it ch es a r e b ein g u s ed , is s u e t h e s a m e com m a n d s on t h e s econ d s w it ch .
Table 10
Scenario 3-2 Cisco IOS command line configuration (802.1Q)
Command
>enable
#configure terminal
#interface gigabitethernet0/1
#switchport trunk encapsulation
dot1q
#switchport trunk allowed vlan 101-
105
#switchport mode trunk
#spanning-tree portfast trunk
#exit
#show lacp 10 internal
#show etherchannel summary
#show interface port-channel10
trunk
#copy running-config startup-config
(For permanent changes only)
Shortcut
>en
#config t
#int gi0/1
#sw tr enc dot
#sw tr ac vl 101-105
#sw mo tr
#sp portf tr
#ex
#sh la 10 i
#sh eth sum
#sh int port-channel 10 tr
#cop ru st
Appendix A: Scenario-based Cisco command line reference 213
Description
Privilege mode
Configure via terminal
Focus on Port 1
Configure Port 1 for tagged VLANs
Configure port for VLANs 101
through 105
Enable trunking on Port 1
Enable portfast on Port 1
Remove focus from Port 1
Show the LACP group 10
configuration
Show the etherchannel configuration
Show the port channel 10 trunk
configuration
Save the running configuration to
NVRAM. Otherwise, the changes
will be lost on the next reboot.