Emulation Button - Brother HL-2400C Service Manual

USER'S GUIDE

EMULATION Button

4–60
This printer has been factory set with the automatic emulation selection
function on. The printer can select the emulation mode automatically
when it receives data from the computer.
When you want to set the emulation mode manually, hold down the Shift
button and press the Emulation button. Then you enter the setting mode
where you can change the emulation.
To set the emulation mode, follow these steps:
1. Press the Sel button to set the printer off-line.
2. Hold down the Shift button and press the Emulation button.
When you enter the setting mode, the display first shows the current
emulation mode with an asterisk.
3. Press the or button until the desired emulation mode appears on
the display.
Display Message
AUTO
HP PCL5C
BR-Script 2
HP-GL
EPSON FX-850
IBMProprinterXL
4. Press the Set button to make the displayed selection effective.
When you select any specific emulation mode other than "AUTO," an
asterisk appears at the end of the display for a short time. Then the
printer automatically exits from the setting mode to the off-line state.
When you select "AUTO," the sub-item "Time Out" for the automatic
emulation selection appears on the display. Go to the next step.
5. Set "Time Out" with the
This time out is the duration during which the printer will not allow an
automatic emulation change. You can set it from 1 second to 99
seconds: the factory setting is 5 seconds.
6. Press the Set button.
The next sub-item "EPSON/IBM" appears on the display.
Emulation Mode
Auto Emulation Selection
HP PCL5C
BR-Script level 2 mode
HP-GL Plotter Mode
EPSON FX-850
IBM Proprinter XL
or button.