Brother HL-2400C Service Manual page 137

Code No.
14-1 CHECK FUSER OIL
14 CHECK
14-2
14 CHECK CLEANING
14-3 CHECK WASTE TONER PACK
14 CHECK
15 MISPRINT
15 MISPRINT
16-1
16 ALIGN
LCD Message
[*5]
FUSER OIL[*F0]
ROLLER[*4][*FC]
TONER PACK[*4]
[*6][*4]
FU.UNIT [*4]
V-16
Description of Message
The engine is idling.
The Ready LED is lit.
Replace the fuser oil bottle with a new
one.
This message will be automatically
cleared by opening & closing the
paper exit cover.
The engine is idling.
The Ready LED is lit.
Replace the cleaning roller with a new
one.
Execute the Clear Care Mode after
the replacement of the cleaning roller
to clear the Care Code [FC].
The engine is idling.
The Ready LED is lit.
Replace the waste toner pack with a
new one.
This message will be automatically
cleared by opening & closing the front
cover while replacing the waste toner
pack. The message can also be
cleared by pressing the Font button.
The engine is idling.
The Ready LED is lit.
[*6] The type of misprint error is
indicated as follows;
NOPQR: No PRREQ-N signal is
available.
PAPER: No paper is available in
the feeder while executing the print
operation after receipt of the print
command.
This message can be cleared by
pressing the Font button.
The engine is stopped.
The Ready LED is lit.
The fusing unit is not installed.
Reconfirm the installation status of the
fusing unit.
This message will be automatically
cleared by opening & closing the
paper exit cover. The message can
also be cleared by pressing the Font
button.