Brother HL-2400C Service Manual page 429

Note
A common use of the flash memory is with FORMS software packages.
With these commercially available software packages you have an option
to send a form to the printer without any data. After you have sent the
form to the printer, you may save the form in the flash memory as a
Macro. Then the next time you want to print this form, you would setup
your FORMS software package to SEND DATA ONLY - USE FORM IN
PRINTER. This process would save you anything from 1 to 4 minutes per
print job.
Select the setting menu and enter the sub-setting menu to change the
settings as follows:
Execute Data
Note
This menu appears only when data has been saved on the card.
When you select "EXECUTE DATA," you can execute any of the data
saved in the SAVE DATA mode.
When you enter this sub-setting menu with the Set button, the printer
prompts you to select the ID of the data.
Select the ID with the
that the printer executes the selected data.
Card List
When you select "CARD LIST" and you press the Set button, the printer
automatically loads paper and starts printing the contents of the installed
flash memory card or HDD card. You can check the contents and the
unused capacity of the card.
or button and press the Set button again, so
CHAPTER 4 CONTROL PANEL
4–35