Brother HL-2400C Service Manual page 431

Notes
When you send data to be saved on the card, it is temporarily stored in the
RAM of the printer. Note the following:

If the received data exceeds the RAM capacity, a memory full error
occurs. You can clear this error with the Continue button. When this
error occurs, only part of the image has been stored in RAM,
therefore, you cannot save the data to the card.

The printer is reset to ensure as much capacity as possible in RAM. If
any data remains, it is printed out first.
After you have finished sending data, press the Set button again, so that
the printer exits from the data reception status.
When you exit from the data reception status, select the data ID with the
button and press the Set button. The printer will then save the
or
received data with the selected ID onto the card.
Notes

When you see an asterisk on the display, the ID number has been used
for other data or a macro. If you select the used ID number, the old
data or macro is erased and replaced with the new data.

Once the data is saved, you can execute it with "EXECUTE DATA"
or with a data execution command.

The data saved in the SAVE DATA mode cannot be run with a macro
execution command in HP PCL5C emulation.
• Save Macro
Note
The "SAVE MACRO" menu appears only in the HP PCL5C emulation
mode.
If you have downloaded a macro into the printer's memory, you can save
the macro on the installed flash memory card or HDD card.
If a macro has been downloaded into the printer's memory and you press
the Set button at "SAVE MACRO," the printer prompts you to select the
ID for the macro.
Select the ID with the
that the printer saves the macro with the selected ID.
button and press the Set button again, so
or
CHAPTER 4 CONTROL PANEL
4–37