Operation Example: Selecting The Parallel Interface - Brother HL-2400C Service Manual

Operation Example: Selecting the Parallel Interface

For this session, select the parallel interface manually as follows:
1. Press the Sel button to set the printer off-line.
2. Press the Mode button and then press the Set Button.
When you enter the interface mode, the display first shows the current
interface with the asterisk.
3. Press the or button until the desired interface appears on the
display.
Display Message
I/F=PARALLEL
I/F=RS-232C
I/F=EXTEND I/O
I/F=AUTO
 Note
The Extended I/O interface is available only when a commercial MIO
 compatible sharing/network card has been installed.
Some models come with the network card pre-installed.
4. Press the Set button to make the displayed selection effective.
An asterisk appears at the end of the display for a short time. Then the
printer automatically exits from the setting menu to the interface
menu.
5. Press the or button until the exit menu appears on the display.
6. Press the Set button.
Then the printer automatically returns to the off-line ready state.
CHAPTER 4 CONTROL PANEL
Interface Mode
Parallel interface
Serial interface
Extended I/O interface
Auto interface selection
4–17