Adjustment Work Procedures; 3.4.1 Adjustment Of Top And Left Margin - Brother HL-2400C Service Manual

3.4

Adjustment Work Procedures

3.4.1 Adjustment of Top and Left Margin

The top and left margins can be adjusted by button operation on the control panel.
<Purpose>
If there is no top margin or left margin set for the print guarantee area or when the MCTL
PCB is replaced, the adjustment of top and left margin will be required.
<Adjustment Method>
1) Execute "GRID PRINT" in Service Mode.
2) Measure the position 'A' and 'B' of top margin.
[Leading edge] (A + B) / 2
3) Measure the position 'C' and 'D' of left margin.
[Left edge] (C + D) / 2
4) If the specification value is not met, implement the adjustment.
i) Execute "43 MARGIN ADJUST" in the FACTORY MODE.
5) After adjustment execute "GRID PRINT" and confirm the margins.
Specification Value 4.5
Specification Value 3.5
Leading edge
A
Left Margin
C
Print
Guarantee
Area
D
Fig.5-2
V-39
1.5mm
1.5mm
B
Feeding Direction