Brother HL-2400C Service Manual page 150

43 MARGIN ADJUST
The position of the top margin and left margin can be confirmed and adjusted within the
range -3.5mm max. and +3.5mm max.
Note:
It is recommended to use the default value in normal use. Do not perform this mode
frequently.
Procedure
Description of Procedures
1) Press the Continue button after selecting
Screen (a) "MARGIN ADJUST".
2) Using the Set or
or LEFT and then press the Continue button.
3) The margins can be adjusted by up to 3.5mm
left and right in 0.5mm steps from the
reference value "0".
Using the Set or
of adjustment by selecting a number
displayed in screen (c) or (d). The amount of
adjustment selected will be displayed at the
upper right corner of Screen (c) or (d).
After confirming the desired amount of
adjustment is displayed, press the Continue
button to set the adjustment.
4) Press the Font button to exit the MARGIN
ADJUST mode.
5) Press the Font button one more time to
return to FACTORY MODE. (e)
(a) (b)
button, select either TOP
(b) (c)
button, select the amount
(b) (d)
(f)
V-29
LCD Message
39 FACTORY MODE
a)
MARGIN ADJUST
43 MARGIN ADJUST
b)
TOP/LEFT/LEFT2
43 TOP -2.0mm
c)
-<765432101>+
43 TOP +2.5mm
d)
-<101234567>+
43 MARGIN ADJUST
e)
TOP/LEFT/LEFT2
39 FACTORY MODE
f)
DP CHECK