Operator Call; Video Controller Mode - Brother HL-2400C Service Manual

2.

OPERATOR CALL

2.1

Video Controller Mode

The Ready LED is lit and an applicable message appears on the liquid crystal display
(LCD) in the following cases;
1) Consumables require to be replenished.
2) Waste toner pack is full of waste toner.
3) Paper jam.
4) Periodic maintenance.
5) Maintenance work incomplete.
The above cases are not regarded as a breakdown, and should be treated in accordance
with Table 8-1;
Display Message
CHECK XX TRAY
12 COVER OPEN FRONT
12 COVER OPEN TOP
12 COVER OPEN REAR
13 JAM XXXXXX
14 NO CARTRIDGE
XXXX COLOR
XX NO CASSETTE
16 TONER EMPTY XXXX
COLOR
XX LOAD PAPER *****
SIZE
Table 8-1
Meaning
No paper in the media
cassette (XX is
TRAY1 / TRAY2)
The front cover is
open
The top cover is open.
The rear access cover
is open.
Paper jam in the
printer. XXXXXX is
DRUM / FEEDER /
INSIDE / REAR.
No toner cartridge in
the printer.
No media cassette.
XX is T1 / T2.
Toner almost empty:
Another 50 pages
may be printed. (The
Alarm LED is lit at the
same time.)
Incorrect size of paper
in the media cassette
XX. XX is T1 / T2.
(The message
appears alternately to
show a particular
size.)
VIII-3
Countermeasure
Check the adjustment lever
at the bottom of the upper
media cassette and adjust to
the correct setting when the
CHECK TRAY1 message
appears.
Load a stack of paper into the
cassette.
Close the front cover.
Close the top cover.
Close the rear access cover.
Remove the jammed paper
from the indicated area.
Install the requested toner
cartridge.
Install the requested media
cassette.
Remove the toner cartridge,
rock it several times by 45 ,
and install it again or replace
the toner cartridge with a new
one.
Load the requested size of
paper in the media cassette
and press the Form Feed
button.