Brother HL-2400C Service Manual page 375

!
Caution
Always wait at least 5 seconds after turning off the power before turning
it back on.
Do not turn the power off while the printer is printing as this may cause a
paper jam and adversely affect the printer.
The printer performs a self-diagnosis at start-up to check its hardware and
software. If the printer should find any problems, the display will change
to show the corresponding error message. See "TROUBLESHOOTING"
in Chapter 6.
The display shows several messages quickly at start-up. If the printer
detects no errors, it automatically goes on-line and the message changes
to show the current printer status and settings as shown below.
LJ READY 001P T1
AUTO
AUTO: The auto emulation selection mode is set.
LJ : The auto emulation selection is set and currently the HP
PCL5C emulation is selected.
READY : The printer is ready to print.
001 : The number of copies to print is set to 1.
P : Portrait print is selected.
T1 : Paper is fed from Tray1.


: Toner cartridges are full. When the toner cartridges become
nearly empty, the
disappears when a color toner is empty.
CHAPTER 2 SETTING UP THE PRINTER





K C M Y


indication blinks. The


indication
2–17