5-16
CHAPTER 5
Installing Modules
Verifying the Installation
Configuring Line Module Redundancy
The Next Step
To verify that the installation is complete:
1
After you have cabled the system for power (see
E-Series
Routers), turn on the power switches.
The system reboots.
2
Issue the show redundancy command, and verify that the display
shows the redundancy hardware.
For information about configuring line module redundancy, refer to
E-Series System Basics Configuration Guide, Chapter 5, Managing Line
Modules and SRP
Modules.
After you install the modules, you can connect cables to the system. Turn
to
Chapter 6, Cabling E-Series
Chapter 6, Cabling
Routers.