Figure 40.4 HTTP Server Configuration: Server Modules
Main Host or Hosts
These dialogs are identical to the ones already described. Refer to Section "Default
Host" (page 756) and Section "Virtual Hosts" (page 758).
40.3 Starting and Stopping Apache
If configured with YaST (see Section 40.2.2, "Configuring Apache with YaST"
(page 755)), Apache is started at boot time in runlevels 3 and 5 and stopped in runlevels
0, 1, 2, and 6. You can change this behavior using YaST's runlevel editor or the command
line tool chkconfig.
To start, stop, or manipulate Apache on a running system, use the init script
/usr/sbin/rcapache2 (refer to Section 20.2.2, "Init Scripts" (page 396) for a
general information about init scripts.). The rcapache2 command takes the following
parameters:
start
Starts Apache if it is not already running.
The Apache HTTP Server
761