Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 51

3.12.2 Expert
If you are an advanced user and want to configure booting or change the time zone or
default runlevel, select the Expert tab. It shows the following additional entries not
contained on the Overview tab:
System
This dialog presents all the hardware information YaST could obtain about your
computer. Select any item in the list and click Details to see detailed information
about the selected item. Advanced users can also change the PCI ID setup and
Kernel Settings by choosing System Settings.
Add-On Products
The added source for add-on media appears in the overview. Before you start the
installation of the SUSE Linux Enterprise, add, remove, or modify add-on products
here if needed.
Booting
►zseries: This module cannot be used to configure the boot loader (zipl) on the
IBM System z platforms. ◄
YaST proposes a boot configuration for your system. Normally, you can leave
these settings unchanged. However, if you need a custom setup, modify the proposal
for your system. For information, see Section 21.3, "Configuring the Boot Loader
with YaST" (page 416).
Time Zone
This is the same as the configuration shown earlier in Section 3.11, "Clock and
Time Zone" (page 29).
Default Runlevel
SUSE Linux Enterprise can boot to different runlevels. Normally there should be
no need to change anything here, but if necessary, set the default runlevel with this
dialog. Refer to Section 20.2.3, "Configuring System Services (Runlevel) with
YaST" (page 400) for information about runlevel configuration.
Installation with YaST 33