Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 114

The info data can be made available to linuxrc in various different ways:
• As a file in the root directory of a floppy that is in the client's floppy drive at instal-
lation time.
• As a file in the root directory of the initial RAM disk used for booting the system
provided either from custom installation media or via PXE boot.
• As part of the AutoYaST profile. In this case, the AutoYaST file needs to be called
info to enable linuxrc to parse it. An example for this approach is given below.
linuxrc looks for a string (start_linuxrc_conf) in the profile that represents the
beginning of the file. If it is found, it parses the content starting from that string and
finishes when the string end_linuxrc_conf is found. The options are stored in the
profile as follows:
....
<install>
....
<init>
<![CDATA[
#
# Don't remove the following line:
# start_linuxrc_conf
#
install: nfs:server/path
vnc: 1
vncpassword: test
autoyast: file:///info
# end_linuxrc_conf
# Do not remove the above comment
#
]]>
</init>
......
</install>
....
linuxrc loads the profile containing the boot parameters instead of the traditional info
file. The install: parameter points to the location of the installation sources. vnc
and vncpassword indicate the use of VNC for installation monitoring. The
autoyast parameter tells linuxrc to treat info as an AutoYaST profile.
96 Installation and Administration
<info_file>
</info_file>