Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 167

YaST
To add a DASD to an installed system, use the YaST DASD module (Hardware
> DASD). In the first screen, select the disks to make available to your Linux instal-
lation and click Perform Action. Select Activate then leave the dialog with Next.
Command Line
Issue the following command:
dasd_configure 0.0.0150 1 0
Replace 0.0.0150 with the actual channel number to which the DASD is attached.
The last zero of the command line should be 1 if the DASD should be accessed in
DIAG mode.
NOTE
In either case, you must run the commands
mkinitrd
zipl
to make the changes persistent.
8.4.8 IBM System z: ZFCP
To add further FCP-attached SCSI devices to the installed system, use the YaST ZFCP
module (Hardware > ZFCP). Select Add to add an additional device. Select the Channel
Number (adapter) from the list and specify both WWPN and FCP-LUN. Finalize the
setup by selecting Next and Close. Verify that the device has been added by checking
the output of cat /proc/scsi/scsi.
NOTE
To make the changes persistent through a reboot, run the following commands:
mkinitrd
zipl
System Configuration with YaST 149