Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 110

natively, create your own custom CD-ROM holding both the installation sources
and the AutoYaST profile.
The following sections provide a basic outline of the procedures for network boot or
boot from CD-ROM.
Preparing for Network Boot
Network booting with Wake on LAN, PXE, and TFTP is discussed in Section 4.1.3,
"Remote Installation via VNC—PXE Boot and Wake on LAN" (page 51). To make
the setup introduced there work for autoinstallation, modify the featured PXE Linux
configuration file (/srv/tftp/pxelinux.cfg/default) to contain the
autoyast parameter pointing to the location of the AutoYaST profile. An example
entry for a standard installation looks like this:
default linux
# default label linux
kernel linux append initrd=initrd ramdisk_size=65536 insmod=e100 \
install=http://192.168.0.22/install/suse-enterprise/
The same example for autoinstallation looks like this:
default linux
# default label linux
kernel linux append initrd=initrd ramdisk_size=65536 insmod=e100 \
install=http://192.168.0.22/install/suse-enterprise/ \
autoyast=nfs://192.168.0.23/profiles/autoinst.xml
Replace the example IP addresses and paths with the data used in your setup.
Preparing to Boot from CD-ROM
There are several ways in which booting from CD-ROM can come into play in Auto-
YaST installations. Choose from the following scenarios:
92 Installation and Administration