Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 969

First, IPL the SUSE Linux Enterprise Server for IBM System z installation system as
described in the Architecture-Specific Information manual. A list of choices for the
network adapter to use is then presented.
Select Start Installation or System then Start Rescue System to start the rescue system.
Depending on the installation environment, you now must specify the parameters for
the network adapter and the installation source. The rescue system is loaded and the
following login prompt is shown at the end:
Skipped services in runlevel 3:
Rescue login:
You can now login as root without a password.
51.7.2 Configuring Disks
In this state, no disks are configured. You need to configure them before you can pro-
ceed.
Procedure 51.3 Configuring DASDs
1 Configure DASDs with the following command:
dasd_configure 0.0.0150 1 0
0.0.0150 is the channel to which the DASD is connected. The 1 means activate
the disk (a 0 at this place would deactivate the disk). The 0 stands for "no DIAG
mode" for the disk (a 1 here would enable DAIG access to the disk).
2 Now the DASD is online (check with cat /proc/partitions) and can
used for subsequent commands.
Procedure 51.4 Configuring a zFCP Disk
1 To configure a zFCP disk, it is necessary to first configure the zFCP adapter. Do
this with the following command:
zfcp_host_configure 0.0.4000 1
nfs nfsboot
Common Problems and Their Solutions 951