Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 44

Figure 3.3 IBM System z: Overview of Available zFCP Disks
To use zFCP disks for the SUSE Linux Enterprise installation, select Configure zFCP
Disks in the selection dialog. This opens a dialog with a list of the zFCP disks available
on the system. In this dialog, select Add to open another dialog in which to enter zFCP
parameters. See Figure 3.3, "IBM System z: Overview of Available zFCP Disks"
(page 26).
To make a zFCP disk available for the SUSE Linux Enterprise installation, choose an
available Channel Number from the drop-down list. Get WWPNs (World Wide Port
Number) and Get LUNs (Logical Unit Number) return lists with available WWPNs and
FCP-LUNs, respectively, to choose from. When completed, exit the zFCP dialog with
Next and the general hard disk configuration dialog with Finish to continue with the
rest of the configuration.
TIP: Adding DASD or zFCP Disks at a Later Stage
Adding DASD or zFCP disks is not only possible during the installation workflow,
but also when the installation proposal is shown. To add disks at that stage,
click Expert and scroll down. The DASD and zFCP entries are shown at the very
bottom.
26 Installation and Administration