Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 165

IMPORTANT: Model Designations
If your model is not included in the device list, try a model with a similar des-
ignation. However, in some cases the model must match exactly, because sim-
ilar designations do not always indicate compatibility.
8.4.1 Infrared Device
Configure an infrared device with Hardware > Infrared Device. Click Start IrDa to
begin configuration. You can configure Port and Limit Baud Rate here.
8.4.2 Graphics Card and Monitor
Configure graphics cards and monitors with Hardware > Graphics Card and Monitor.
It uses the the SaX2 interface, described in Section 8.14, "SaX2" (page 191).
8.4.3 Printer
Configure a printer with Hardware > Printer. If a printer is properly connected to the
system, it should be detected automatically. Find detailed instructions for configuring
printers with YaST in Section 23.4, "Setting Up a Printer" (page 443).
8.4.4 Hard Disk Controller
Normally, the hard disk controller of your system is configured during the installation.
If you add controllers, integrate these into the system with Hardware > Disk Controller.
You can also modify the existing configuration, but this is generally not necessary.
The dialog presents a list of detected hard disk controllers and enables assignment of
the suitable kernel module with specific parameters. Use Test Loading of Module to
check if the current settings work before they are saved permanently in the system.
System Configuration with YaST 147