Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 970

2 After the adapter is activated, a disk can be configured. Do this with the following
3 Now the zFCP disk is online (check with cat /proc/partitions) and can
51.7.3 Mounting the Root Device
If all needed disks are online, you should now be able to mount the root device. Assum-
ing that the root device is on the second partition of the DASD device (/dev/dasda2),
the corresponding command is mount /dev/dasda2 /mnt.
IMPORTANT: File System Consistency
If the installed system has not been shut down properly, it may be advisable
to check the file system consistency prior to mounting. This prevents any acci-
dental loss of data. Using this example, issue the command fsck /dev/dasda2
to ensure that the file system is in a consistent state.
By just issuing the command mount, it is possible to check whether the file system
could be mounted correctly.
952 Installation and Administration
0.0.4000 is the channel to which the adapter is attached and 1 stands for acti-
vate (a 0 here would deactivate the adapter).
command:
zfcp_disk_configure 0.0.4000 1234567887654321 8765432100000000
0.0.4000 is the previously-used channel ID, 1234567887654321 is the
WWPN (World wide Port Number), and 8765432100000000 is the LUN
(logical unit number). The 1 stands for activating the disk (a 0 here would deac-
tivate the disk).
used for subsequent commands.
1