Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 144

Hide thumbs Also See for LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION:
Table of Contents

Advertisement

optimize the performance of RAID 0. After creating all the partitions to use with RAID,
click RAID > Create RAID to start the RAID configuration.
In the next dialog, choose between RAID levels 0, 1, and 5 (see Section 7.2.1, "RAID
Levels" (page 124) for details). After Next is clicked, the following dialog lists all parti-
tions with either the "Linux RAID" or "Linux native" type (see Figure 7.6, "RAID
Partitions" (page 126)). No swap or DOS partitions are shown. If a partition is already
assigned to a RAID volume, the name of the RAID device (for example, /dev/md0)
is shown in the list. Unassigned partitions are indicated with "--".
Figure 7.6 RAID Partitions
To add a previously unassigned partition to the selected RAID volume, first click the
partition then Add. At this point, the name of the RAID device is entered next to the
selected partition. Assign all partitions reserved for RAID. Otherwise, the space on the
partition remains unused. After assigning all partitions, click Next to proceed to the
settings dialog where you can fine-tune the performance (see Figure 7.7, "File System
Settings" (page 127)).
126
Installation and Administration

Advertisement

Table of Contents
loading

This manual is also suitable for:

Suse linux enterprise server 10 sp3

Table of Contents