Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 600

Choose the Device Settings that fit your devices (usually this would be Compatibility
mode). Specify both your IP address and the IP address of the remote partner. If needed,
adjust the MTU size with Advanced > Detailed Settings. Leave the network configuration
with Next and Finish.
WARNING
The use of this interface is deprecated. This interface will not be supported in
future versions of SUSE Linux Enterprise.
The lcs Device
To add an lcs (IBM OSA-2 Adapter) interface to the installed system, start the YaST
network card module (Network Devices > Network Card). Select one of the devices
marked IBM OSA-2 Adapter and click Configure. Enter the needed port number, some
additional options (see the Linux for IBM System z: Device Drivers, Features, and
Commands manual for reference at
linux/linux390/documentation_novell_suse.html), your IP address,
and an appropriate netmask. Leave the network configuration with Next and Finish.
The IUCV Device
To add an iucv (IUCV) interface to the installed system, start the YaST network card
module (Network Devices > Network Card). Select a device marked IUCV and click
Configure. YaST prompts you for the name of your IUCV partner. Enter the name (this
entry is case-sensitive) and select Next. Specify both your IP address and the IP address
of your partner. If needed, adjust the MTU size with Advanced > Detailed Settings.
Leave the network configuration with Next and Finish.
WARNING
The use of this interface is deprecated. This interface will not be supported in
future versions of SUSE Linux Enterprise.
582 Installation and Administration
http://www.ibm.com/developerworks/