Novell LINUX ENTERPRISE SERVER 10 SP2 - INSTALLATION AND ADMINISTRATION Installation Manual page 587

7 Click OK.
8 Click Next.
9 To activate the configuration, click Finish.
Configuring Routing
To make your machine communicate with other machines and other networks, routing
information must be given to make network traffic take the correct path. If DHCP is
used, this information is automatically provided. If a static setup is used, this data must
be added manually.
1 Select a card from the list of detected cards in the YaST network card configura-
tion module and click Edit.
2 In the Address tab, click Routing.
3 Enter the IP of the Default Gateway.
4 Click OK.
5 Click Next.
6 To activate the configuration, click Finish.
Adding Special Hardware Options
Sometimes a module of a network card needs special parameters to work correctly. To
set them with YaST, proceed as follows:
1 Select a card from the list of detected cards in the YaST network card configura-
tion module and click Edit.
2 In the Address tab, click Advanced > Hardware Details.
3 In Options, enter the parameters for your network card. If two cards are configured
that use the same module, these parameters are used for both.
4 Click OK.
Basic Networking 569