Ospf Interface Configuration - HP 438031-B21 - 1:10Gb Ethernet BL-c Switch Cli Reference Manual

Table 133 OSPF Summary Range Configuration commands
Command
no area-range <1-16> enable
no area-range <1-16>
show ip ospf area-range <1-16>

OSPF Interface configuration

The following table describes the OSPF Interface Configuration commands.
OSPF Interface Configuration commands
Table 134
Command
ip ospf area <0-2>
ip ospf priority <0-255>
ip ospf cost <1-65535>
ip ospf hello-interval
<1-65535>
ip ospf dead-interval
<1-65535>
ip ospf transit-delay
<1-3600>
ip ospf retransmit-
interval <1-3600>
[no] ip ospf key <key
string>
[no] ip ospf message-
digest-key <1-255>
ip ospf enable
Description
Disables the OSPF summary range.
Command mode: Router OSPF
Deletes the OSPF summary range.
Command mode: Router OSPF
Displays the current OSPF summary range.
Command mode: All except User EXEC
Description
Configures the OSPF area index.
Command mode: Interface IP
Configures the assigned priority value to the OSPF interfaces.
(A priority value of 255 is the highest and 1 is the lowest. A priority value of 0
specifies that the interface cannot be used as Designated Router (DR) or Backup
Designated Router (BDR).)
Command mode: Interface IP
Configures cost set for the selected path—preferred or backup. Usually the cost
is inversely proportional to the bandwidth of the interface. Low cost indicates
high bandwidth.
Command mode: Interface IP
Configures the interval in seconds between the hello packets for the interfaces.
Command mode: Interface IP
Configures the health parameters of a hello packet, which is set for an interval
of seconds before declaring a silent router to be down.
Command mode: Interface IP
Configures the transit delay in seconds.
Command mode: Interface IP
Configures the retransmit interval in seconds.
Command mode: Interface IP
Sets the authentication key to clear the password.
Command mode: Interface IP
Assigns an MD5 key to the interface.
Command mode: Interface IP
Enables the OSPF interface.
Command mode: Interface IP
Configuration Commands
147