HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 25

2. Attach the network cable to the RJ-45 connector on the rear
!
of the tower.
3. On the front of the server/tower, switch on the power. Verify
that:
Power
switch
• The ON/BUSY indicator lights on the HP CD-ROM drives
go on.
• The 4 indicator lights on the server module (illustrated
above) flash during a power-on self-test.
When the Status indicator (yellow) stops flashing and
remains off, the server/tower is ready for use. Depending
on the number of drives in use, this may take a few seconds
to five minutes.
The server auto-negotiates the link speed—10 or 100 mega-
bits per second—and duplex setting—full or half—with
other devices on the network.
4. Press the Stop/Eject button (see illustration on page 2-12) to
access the tray of the topmost CD-ROM drive, place a compact
disc into the tray, and press Stop/Eject again to close it. Verify:
• The drive's ON/BUSY indicator light turns off and the
DISC light goes on. If either one flashes continuously,
then either the disc is not standard or there is a problem
with the drive; refer to chapter 9, "Troubleshooting".
• The server's CD indicator light (green) goes on. If it does
not, then verify your connections and cycle power (switch
power off and wait 10 seconds and then switch power on
again) to the server/tower. If CD still does not go on, refer
to chapter 9, "Troubleshooting".
Repeat step 4 for all drives (including the 7-bay tower if used).
Status indicator
CD indicator
Network indicator
Power indicator
Installing Your Tower 2-11