HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 21

1. Place the tower on an even surface, like a table or work
bench. Do not use an uneven surface like a carpeted floor.
Make sure the tower is powered off.
2. Use the key to unlock the front cover. The cover is locked when
the key index points to the right. The cover is unlocked when
the key index points up.
3. Place both of your hands on the top two corners of the front
cover and carefully pull it towards you. The cover will still be
attached at the bottom.
4. You can now remove the front cover by lifting it up, making
sure that the flange at the bottom of the cover has cleared the
opening of the tower casing. Set the front cover aside.
5. With the front cover off, you can remove a filler panel covering
the bay. Hook your finger behind the right or left end and
nudge it out slightly. Repeat on the other side. Repeat on each
side alternately until the panel pops off.
With the front cover off, you can remove a CD-ROM drive
module by placing both hands on the two handles on both
sides. Pull the module using even pressure on both handles.
6. You can install a CD-ROM module by aligning the rails with
the two grooves provided in each bay of the tower. Slide the
module in by holding the two handles on both sides and
pushing firmly until it is seated properly. Just before it stops,
you should feel the module inserting into its socket.
You can install a filler panel to cover an empty bay. Align the
studs on back of the filler panel with the grooves on the sides
of the tower. Align the pegs with the holes in the metal at
both sides of the front of the tower. Gently push in the left or
right side of the panel, then push in the other side, until it
pops into place. No screws are needed to secure the panel.
Alignment peg
Hole
Stud
7. When you are finished, replace the front cover by first hooking
!
the flange of the cover into the bottom of the tower case. Close
the cover by pushing it towards the main body of the tower. Be
sure to lock the cover using the key.
8. You can now switch on power to the tower.
Filler Panel (back view)
Installing Your Tower 2-7