HP J3278B - SureStore CD-ROM Server/Tower 7 NAS Server User Manual page 20

Installing the
Drive Module
CAUTION!
2-6 Installing Your Tower
While doing the procedure in "Installation Steps", take the pre-
cautions listed below:
Make sure that the towers are powered off.
Do not attempt to move or carry a tower without hooking the
cover at the bottom and locking the front cover lock.
When replacing the front cover of the tower, make sure that
the flange on the bottom of the cover is engaged in the cut-
out opening of the main body. Locking the cover without
properly aligning the flange can damage the tower case or
cover. The drives can be damaged if moved in this condition.
Do not push the drive module in by pushing on the bezel of
the CD-ROM drive itself. This may result in damage to the
drive's door, or you might snap the plastic bezel of the drive.
Always use the metal handles provided with the drive.
Make sure you align the two side rails ofthe CD-ROM drive
module with the grooves in the walls of the tower. If the
drive module is not in the grooves, the tower will not func-
tion properly.
Do not force the drive module into the tower, or you may
damage the circuit board. Firm pressure should be ade-
quate.
Do not use tools of any kind! If the drive module will not
install properly, remove it and call HP for support.
Replace the front cover of the tower by hooking it at the
bottom first. Then close the cover at the top. Lock it.
Installation Steps