Selecting A Loop - DigiTech JAMMAN - MANUAL 2 Owner's Manual

Selecting a Loop

The JamMan Stereo has two banks of loop memory, internal and optional
®
card memory. There are 99 memory locations available in each of these
banks for a total of 198 memories when an optional SD/SDHC memory card
is installed. The card memory bank is only available when a memory card is
installed.
To select loops, Press either the or footswitches or use
LooP UP LooP DoWN
the knob next to the .
LooP seLect DIsPLaY
Pressing the footswitch will select the next loop above the current
LooP UP
loop. Pressing the footswitch will select the previous loop below.
LooP DoWN
Pressing and holding either of these footswitches will scroll through the loop
memories in its respective direction. The will show the memory
DIsPLaY
location number as these buttons are pressed.
When Loop 99 is reached, pressing the footswitch will return to the
LooP UP
first memory location (1 will be shown in the display). Likewise, if Loop 1 is
reached, pressing the footswitch will return to the last memory
LooP DoWN
location (99 will be shown in the ). If an optional memory card
DIsPLaY
is installed, pressing the or footswitches will alternate
LooP UP LooP DoWN
through one bank of memories and then the next (1-99 internal and then
1-99 card). The LED will light when memories are selected on the
caRD MeM
optional external card.
As loops are selected, the or LED will flash as the loop is loaded
LooP sINgLe
from internal or optional card memory. Trying to store, copy, or change the
loop tempo during this time is ignored (bu will be displayed indicating the
JamMan Stereo is busy loading a loop from memory).
22