Best Practices - Cisco 7925G Administration Manual

Best Practices

• Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Firmware Release 1.3(1) or later
• Configuration Utility (CU) for Wavelink Avalanche
• DHCP server
• Cisco Unified Communications Manager
Best Practices
This section describes the best practices recommended for setting up and using the CU on the Wavelink
Avalanche server.
• Ensure that the phone is registered to Cisco Unified Communications Manager.
• Try out this process with one or two phones before deploying to many phones.
• Set up a VLAN that has access only to the Wavelink server.
• Configure DHCP Option 149 with the Wavelink server IP address. If you do not configure this option,
• Configure a Cisco Access Point to use a default SSID of "cisco" with open authentication and no
Wavelink Server IP Address Setup
If you did not configure DHCP Option 149 with the Wavelink server IP address, you must manually assign
it.
Note Do not perform this task if you previously configured the Wavelink server address using DHCP Option
149.
The following sections describe the methods to assign the Wavelink server on the phone.
Set Up Wavelink Server Address from Phone
To assign the Wavelink server from the phone, follow these steps.
Cisco Unified Wireless IP Phone 7925G, 7925G-EX, and 7926G Administration Guide
134
◦ Avalanche Manager Agent
◦ Avalanche Management Console
see Set Up Wavelink Server Address from Phone, on page
encryption.
Wavelink Avalanche Server
134.