Sending A Signal From A Mix Channel To A Matrix Bus - Yamaha CS1D Operating Manual

Sending a signal from a MIX channel to a MATRIX bus

Here's how the signal sent from an input channel to a MIX bus can be output to a MATRIX bus.
[Procedure]
1. Make sure that an appropriate signal is being sent
from an input channel to a MIX bus.
2. In the MIX OUTPUT block, turn on the MIX [TO
MTRX] switch of the MIX channel whose signal
you wish to send to the MATRIX bus.
If this switch is off, no signal will be sent from that
channel to the MATRIX bus.
3. In the LCD FUNCTION ACCESS block, press the
OUTPUT [MATRIX/ST] switch several times to
access the following MATRIX/ST ROUTING
screen.
LCD FUNCTION ACCESS
block
OUTPUT [MATRIX/ST] switch
MATRIX/ST ROUTING screen (MATRIX/ST func-
tion)
In the MATRIX/ST ROUTING screen you can make
settings for the signals sent from the MIX channels to
the MATRIX buses/STEREO bus. The vertical col-
umn in the upper part of the screen is the destination
MATRIX bus, and the horizontal row is the source
MIX channel.
Chapter 5. Basic operation for output channels
Detail of MATRIX/ST ROUTING
Enable/cancel pairing for two adjacent
odd-numbered
MATRIX buses.
MIX channel (source)
MIX TO STEREO
This is an on/off switch and destination selection for
the signal sent from the MIX channel (horizontal row)
to the STEREO bus.
MIX TO MATRIX
This is an on/off switch and a destination selection for
the signal sent from the MIX channel (horizontal row)
to the MATRIX bus.
4. Use the on-screen buttons in the MIX TO MATRIX
section to select the destination of the signal sent
from the MIX channel to the MATRIX channel.
The following buttons can be used.
PRE FADER ....... Immediately before the MIX
[LEVEL] encoder
POST FADER .... Immediately after the MIX
[LEVEL] encoder
POST ON ........... Immediately after the MIX [ON]
switch
Hint
The ON/OFF switches in the MIX TO MATRIX sec-
tion are on/off switches for the signal sent from the
MIX channel to the MATRIX bus. They are linked
with the MIX [TO MTRX] switches of the MIX
OUTPUT block.
even-numbered
Specify the output level of the
signal sent from the MIX chan-
nel (horizontal row) to the
MATRIX bus.
63