Yamaha CS1D Operating Manual page 421

2
2 DEFINE
From the following choices, this selects the signal
that will be monitored when "DEFINE" is selected in
the MONITOR SOURCE section.
MIX 1–48............Output signal of MIX buses 1–48
MATRIX 1–24 ....Output signal of MATRIX buses
1–24
2TR IN 3–6 .........Input signal from 2-TRACK IN
DIGITAL jacks 3–6 of the CS1D
DIRECT IN.........The input signal from the con-
nector selected in the DIRECT
IN SELECT section (3)
3
3 DIRECT IN SELECT
Select the two input connectors that will be moni-
tored when "DIRECT IN" is selected as the signal for
monitoring.
When you click the button, a popup window will
appear in which you can select the unit number/slot
number/channel for the input jack.
The input level of the signal is shown by the level
meter at the left.
If an input card with head amp is selected, this screen
will allow you to switch between A/B jacks, turn
MON/CUE (monitor/cue) functions
phantom power on/off, switch between normal/
inverted phase, and adjust the input gain.
4
5
4 Level meters
This is a peak level meter that shows the pre-fader
level of MONITOR OUT connector B (i.e., the level
before the MONITOR B [LEVEL] volume).
The level of the signal that is output from the MON-
ITOR OUT connector will vary depending on the
state of the MONITOR B [LEVEL] volume and the
[ON] switch.
5 ON/OFF
This button is an on/off switch for the signal that is
output from the MONITOR OUT jacks B.
This will not affect the output to the PHONES
MONITOR B jack.
73