In Dca/Mute Functions; Set Dca, And Mute Group; Dca Assign - Yamaha CS1D Operating Manual

Input functions

IN DCA/MUTE functions

Set DCA, and mute group

DCA ASSIGN

[Functions]
Assign input channels to DCA groups 1–12 so that they can be controlled by DCA faders 1–12.
Console
In the LCD FUNCTION ACCESS
block, press the INPUT [DCA/
MUTE] switch (Press repeatedly
until the screen shown at the right
appears.)
Display
MENU button INPUT DCA/
MUTE button DCA ASSIGN tab
[Screen functions]
1
2
1 These are the DCA group numbers. The number
corresponding to the grid where the cursor is cur-
rently located will be highlighted.
2 These are the eight-character names displayed in the
DCA fader section. You can also click here and mod-
ify the names of the DCA faders.
150
3
3 Grid
This is the grid where input channels (horizontal
rows) can be assigned to DCA groups (vertical col-
umns). Move the cursor to the desired grid location,
and press the [ENTER] switch (or click) to set/cancel
the assignment. To access channels that are not cur-
rently displayed, use the horizontal scroll bar.
Hint
It is possible to assign a single input channel to two
or more DCA groups for multiple DCA control. For
details refer to the section on basic operation.
DCA groups 9–12 can be used for either input chan-
nels or output channels. However, it is not possible
to use the same DCA fader for both inputs and out-
puts. For this reason, input channels cannot be
assigned to a DCA group 9–12 to which an output
channel has already been assigned.