Yamaha CS1D Operating Manual page 380

Global functions
Hint
If you selected Multi mode in step 3, you can use
MIDI channels 1–16/program changes 1–128.
If you selected Single mode in step 3, you can use
only program changes 1–128 of the MIDI channel
that is selected by the RX CH knob.
If you selected Single mode in step 3 and turned the
BANK button on, you can use bank select 1–16/pro-
gram changes 1–128 of the MIDI channel that is
selected by the RX CH knob. In this case, the number
shown in the CH column of the Program Change
Event list will be the bank number.
6. Click one of the following buttons to select the type
of event.
1) SCENE
Scene memory recall operation
2) EFFECT
Effect recall operation
3) NO ASSIGN
No event assignment
7. If you selected 1) in step 6, select the number of the
scene to be recalled from the list in the right side of
the popup window, and click the OK button.
8. If you selected 2) in step 6, use the buttons in the
lower left of the popup window to select the inter-
nal effect (1–8) that the recall operation will affect,
then use the list shown at the right to select the
effect library that will be recalled, and click the OK
button.
9. Repeat steps 5–8 until you have assigned all the
necessary events to program numbers.
10. Transmit program change (or bank select + pro-
gram change) messages from the external device on
the appropriate MIDI channel.
The event assigned to that program number will be
executed.
Hint
Program changes can also be transmitted from the
PM1D system to an external device. To do so, con-
nect the MIDI OUT connector of the CS1D or
DSP1D-EX {DSP1D} to the MIDI IN connector of
the external device, and execute the event on the
CS1D that was assigned to the program number in
step 9.
If the same event is assigned to more than one pro-
gram number, the lowest-numbered program change
will be transmitted.
32