Improved screen encoder operation
Improved screen encoder operation
You can now use the screen encoders to edit EQ and dynamics parameters on the SELECTED
CHANNEL VIEW screen.
EQ
The encoder numbers displayed on the screen correspond to the actual screen encoder numbers.
Improved channel name display
In SENDS ON FADER mode, the channel on/off status is now indicated in the channel name display
area on the panel.
Channel on
ch 1
CH 1
-∞
Dynamics
Channel off
ch 1
CH 1
-∞
During channel mute, the
channel name will be
highlighted in the same way
as when the channel is off,
but it will also be flashing.
Improved HY SLOT4 feature
HY SLOT4 (HY SLOT3 on the CSD-R7) now supports input/output patches.
Due to this improvement, output channels are now patched via the OUTPUT tab, not on the
RECORDING tab.
Addition input patch setting
When you modify input patches, you can now select TAKE FROM PORT or TAKE FROM
CHANNEL. If you select TAKE FROM PORT, the HA parameter settings retained by the patched
port will be used as is. If you select TAKE FROM CHANNEL, the HA parameter settings retained by
the input channel will be copied to the destination port.
INPUT patch screen
10
CONTENTS
RIVAGE PM series V2.5 Supplemental Manual