Chapter 3. Audio Connections And Patching; Audio Connections; Audio Connections For An Analog Input Unit - Yamaha CS1D Operating Manual

Chapter 3. Audio connections and patching

This chapter explains how to connect input/output devices such as mics and speaker systems to the input/output units
and to the CS1D console, and patch them to input channels and output channels.
The "CS1D Operation Manual (Basic Operation)" assumes that the components of the PM1D system are connected
appropriately, and that all components are operating correctly. For details on connecting the components of the
PM1D system and checking their operation, refer to the "CS1D Operation Manual (Start-up)."

Audio connections

This section explains how to make audio connections for the input/output units and the console.

Audio connections for an analog input unit

Two types of input card can be installed in the AI8 analog input unit: the LMY2-ML mic/line input card and the LMY4-
AD AD card. The two cards differ in specifications and number of channels.
Mic/line input card (LMY2-ML)
The LMY2-ML provides two (A and B) XLR-3-31
(balanced) input jacks for each of input channels 1
and 2. However, only one jack (A or B) at a time can
be used for each channel. (You can switch between A
and B in the SELECTED INPUT CHANNEL block
or in the display.)
LMY2-ML connection
1 2 3 4 5
AI8 analog input unit
MIC/Line-Eingangsplatine
Mic
(LMY2-ML)
Mic
22
6 7 8
INPUT UNIT NO.
PHANTOM MASTER
ON
+48V
OFF
POWER
ON/ OFF
ANALOG INPUT BOX
Synthesizer
Sources ranging from mics to line level devices can
be connected to these jacks.
The pin wiring is as follows.
Input jack wiring
Male XLR plug
Hint
If you wish to supply +48 V phantom power to the
connected device, turn on the PHANTOM MASTER
switch (located on the front panel of the AI8), and
also turn on the [+48V] switch for the corresponding
input channel ( p.46).
If different sets of audio sources (that you will not
use simultaneously) are connected to LMY2-ML
jacks 1A and 1B, and to 2A and 2B, they can share
input channels of different settings simply by switch-
ing between A and B on the CS1D console.
1 (ground)
3 (cold)
2 (hot)