Controlling A Dca Group - Yamaha CS1D Operating Manual

Controlling a DCA group

By using the DCA faders in the DCA GROUP block of the console, you can control the levels of each DCA group.
[Procedure]
1. Assign input channels/output channels to a DCA
group.
2. In the DCA GROUP block of the console, turn on
the FADER STATUS [DCA] switch (the LED will
light).
DCA GROUP
block
37–48
DCA
FADER
STATUS
The FADER STATUS [DCA] switch lets you use the
DCA faders to control DCA groups. (The DCA fad-
ers can also be used as input channel or MIX channel
faders.)
3. Operate DCA faders 1–12.
The levels of the input channels or output channels
assigned to each DCA fader will be controlled.
Hint
DCA group levels can also be adjusted in the display
(IN DCA/MUTE function DCA GROUP ASSIGN
screen, OUT GROUP DCA/MUTE function DCA
ASSIGN screen).
FADER STATUS
[DCA] switch
Chapter 7. DCA groups/Mute groups
4. To mute a specific DCA group, press the DCA
[MUTE] switch (located in the DCA GROUP block)
for that DCA group.
DCA GROUP
block
The DCA [MUTE] switch LED will light, and the
input channels/output channels included in that
DCA group will be set to a state identical to when the
DCA fader has been lowered to the minimum posi-
tion (– dB).
5. If you press the switch once again, the DCA
[MUTE] LED will go dark, and muting will be
defeated.
Hint
DCA group operations can also be performed in the
display (IN DCA/MUTE function DCA GROUP
ASSIGN screen, OUT DCA/MUTE function DCA
GROUP ASSIGN screen).
DCA [MUTE]
switch
95