Yamaha CS1D Operating Manual page 210

CS1D Operating Manual (Basic Operation)
When you click one of the above buttons, you will be
able to use the DCA faders to operate the graphic EQ.
The center line of the selected range of faders will
change to red in the display.
Hint
While the GEQ PARAMETER screen is displayed,
you can also perform operations using the DCA fad-
ers by holding down the [SHIFT/GRAB] switch and
pressing the [DCA STATUS] switch. The frequency
range selected at this time will be the same as in the
following diagram.
At this time, the [FADER STATUS] switches in the
DCA GROUP block of the CS1D will function as
graphic EQ band select switches, as shown in the fol-
lowing diagram.
FADER STATUS switches
10 11 12
5. Operate DCA faders 1-12.
The corresponding frequency bands will be cut or
boosted.
138
No function
IN
1.60k–20.0k
1–12
200–2.50k
13–24
20–250
25–36
No function
37–48
OFF
DCA
FADER
STATUS
6. If you wish to use the DCA faders to control other
bands, repeat steps 4–5.
7. When you are finished using the DCA faders to
control the graphic EQ, press the [DCA] switch of
the FADER STATUS section. Alternatively, click the
OFF button in the ASSIGN TO DCA FADERS sec-
tion of the GEQ PARAMETER screen.
The [FADER STATUS] switch will return to the nor-
mal condition, and the DCA faders will function as
control faders for the DCA groups.
If you again wish to assign the graphic EQ to the
DCA faders, click one of the buttons in the ASSIGN
TO DCA FADERS section of the GEQ PARAMETER
screen.
Hint
The settings of the GEQ function are saved as part of
a scene. In addition, the settings of a GEQ module
can be saved in the GEQ library independently of the
scene memory. For details refer to "CS1D Reference
Manual (Software)".
When you exit the GEQ screen, the assignments to
the DCA faders will be cancelled forcibly. At this
time, the [FADER STATUS] switches of the DCA
GROUP block will return to their previous state.