Yamaha CS1D Operating Manual page 506

Input functions
4
5
6 8
4 VARI PAN LINK
This button specifies whether or not the PAN knob
that appears in the screen (at the location of 3 when
you pair VARI type MIX buses can be set indepen-
dently or will be linked with the TO ST PAN knob
(8).
If this button is on, the two PAN knobs will be linked
as follows.
INPUT CHANNEL
FADER
ON PAN
LEVEL
MIX1/2 (VARI)
This parameter is valid for all signals sent to VARI
type MIX buses from the corresponding channel.
5 FIXED MIX PAN
When sending the signal from the input channel/ST
IN channel to a FIX type MIX bus, this button selects
whether the pre-pan signal or the post-pan signal
will be sent.
When this button is on, the pre-pan signal will be
sent. When this button is off, the post-pan signal will
be sent.
Signal flow when FIXED MIX PAN is off
INPUT CHANNEL
FADER
PAN
ON
MIX1 (FIX)
MIX2 (FIX)
158
7
0 9
......
......
PAN
ON
PAN
......
......
ON
ON
Signal flow when FIXED MIX PAN is on
INPUT CHANNEL
FADER
PAN
ON
This parameter is valid for all signals sent to FIX
type MIX buses from the corresponding channel.
6 TO ST (to stereo)
This button specifies whether or not the signal from
the input channel/ST IN channel will be sent to the
STEREO bus.
This is linked with the [TO ST] switch in the
SELECTED INPUT CHANNEL block of the CS1D.
7 PRE FADER/PRE EQ buttons
When the PRE/POST button is set to "PRE" for a
VARI type MIX bus, this button lets you specify in
greater detail the location from which the signal will
be output from the input channel/ST IN channel.
When the PRE FADER button is on
The signal will be sent from immediately before the
fader.
When the PRE EQ button is on
The signal will be sent from immediately before the
EQ.
This parameter is valid for all signals that are sent
from the corresponding channel to a VARI type
MIX bus whose PRE/POST button is set to "PRE."
8 PAN
This adjusts the position of the signal that is sent
from the input channel/ST IN channel to the STE-
REO bus. (The current value is shown in the numer-
ical box immediately below.)
This is linked with the INPUT [PAN] encoder in the
INPUT block of the CS1D.
9 PAN MODE
This specifies whether or not pan settings will be
linked between adjacent odd-numbered
numbered input channels (or between the left and
right channels of a ST IN channel).
You can select only one of the following three but-
tons.
INDIVIDUAL
In this mode, the two pan settings are independent.
GANG PAN
The two pan settings will be linked in the same direc-
tion. If this button is turned on when the two pan
......
......
MIX1 (FIX)
ON
ON
MIX2 (FIX)
even-