Yamaha CS1D Operating Manual page 455

8
3 MIX TO MATRIX ON/OFF (MIX
off)
This button is an on/off switch for the signal that is
sent from the MIX channel/STEREO A/B to the
MATRIX bus. This is linked with the [TO MATRIX]
switch on the MIX OUTPUT block of the console.
When this button is off, no signal will be sent from
that channel to the MATRIX bus.
4 PRE FADER/POST FADER/POST ON
These buttons select the location at which the signal
will be sent from the MIX channel/STEREO A/B
channel to the MATRIX bus.
When the PRE FADER button is on
The signal from immediately before the fader will be
sent.
When the POST FADER button is on
The signal from immediately after the fader will be
sent.
When the POST ON button is on
The signal from immediately after the MIX [ON]
switch/STEREO [ON] switch on the CS1D will be
sent.
This parameter affects all signals that are sent from
the corresponding channel to the MATRIX buses.
5 ON/OFF (MIX STEREO on/off)
This button is an on/off switch for the signal that is
sent from the MIX channel to the STEREO bus. This
is linked with the [TO ST] switch on the MIX OUT-
PUT block of the console.
When this button is off, no signal will be sent from
that channel to the STEREO bus.
6 PRE/POST (pre-fader/post on)
This button selects the location at which the signal is
sent from the MIX channel to the STEREO bus.
If this is turned on (POST), the signal after the [ON]
switch will be sent. If this is turned off (PRE), the
pre-fader signal will be sent.
3
4
5
7
6
MATRIX on/
MATRIX/ST (matrix/stereo) function
7 PAN (MIX STEREO pan)
This knob sets the panning of the signal that is sent
from the MIX channel to the STEREO bus.
If the [TO ST PAN] switch is turned on in the
SELECTED OUTPUT CHANNEL block of the CS1D
console, this knob will be linked with the [PAN]
encoder of the SELECTED OUTPUT CHANNEL
block.
Hint
If the send source is the STEREO A/B channel,
parameters 5–7 will not be displayed.
8 Pairing/send source channel
This displays the number and short name of the send
source MIX channel/STEREO A/B channel and its
pairing status.
You can also click the heart symbol to set/defeat pair-
ing.
107