Yamaha CS1D Operating Manual page 274

CS1D Reference Manual (Hardware)
When MIX channels are paired
ON
MIX 1/2
BALANCE
MIX CHANNEL
OUTPUT LEVEL BALANCE
MIX 1
MIX 2
0 MIX [INS] LED
This LED indicates the insertion status of the MIX
channel.
When insertion is on, the switch LED will light, and
the insert out/in point specified in the display (OUT-
PUT PATCH function INSERT PATCH screen) will
be enabled.
A MIX [CUE] switch and LED
This switch monitors the currently selected MIX
channel.
When this switch is pressed, the PFL (pre-fader lis-
ten) or POST ON (after the [ON] switch) signal of
the corresponding MIX channel will be sent to the
CUE bus, and can be monitored from the CUE OUT
jacks, MONITOR OUT jacks A, or PHONES jack.
The location of the signal that is sent to the CUE bus
and the monitoring method can be switched from
the console in the MASTER block CUE section, or in
the display (MON/CUE function CUE/SOLO
screen).
B MIX [SEL] switch and LED
This switch selects the MIX channel that your opera-
tions will affect.
The MIX [SEL] LED of the currently selected MIX
channel will light.
44
ON
MIX 1/2
OUTPUT
LEVEL
PAIR
ON
The MIX channel selected by this switch can be con-
trolled in the SELECTED OUTPUT CHANNEL
block.
It will also be reflected by the settings in the display.
Hint
If the selected MIX channel is paired, the MIX [SEL]
LED of the other MIX channel of the pair will blink.
You can also use the MIX [SEL] switches to set/defeat
pairing.
The MIX channel shown by the INPUT block MIX
SEND [NAME] indicator and the MIX SEND
[NUMBER] indicator will also follow the operation
of the MIX [SEL] switch. (However, INPUT blocks
whose [LOCAL] LED is lit are excepted.)
[Procedure]
Using the MIX [SEL] switches to set/defeat pair-
ing of MIX channels
1. For adjacent odd and even-numbered MIX chan-
nels, hold down one [SEL] switch and press the
other [SEL] switch.
The MIX [PAIR] LED will light, and the two MIX
channels will be paired.
The direction in which the channel parameters are
copied will depend on the order in which the [SEL]
switches are pressed. When creating a pair, the
parameters of the channel you pressed first will be
copied to the channel that you pressed later, and then
the parameters will be linked.
For example if you wish to pair MIX 1 and MIX 2,
hold down the MIX 1 [SEL] switch and press the
MIX 2 [SEL] switch. The state of MIX 1 will be cop-
ied to MIX 2. For details on the parameters that are
copied/linked for a pair, refer to "CS1D Reference
Manual (Appendices)" ( p.45).
If you wish to reset the parameters, do so from the
screen.
2. To defeat pairing, hold down the MIX [SEL] switch
for one of the paired channels, and press the MIX
[SEL] switch for the other channel.