Input Section; Delay Section - Yamaha CS1D Operating Manual

CS1D Reference Manual (Hardware)

INPUT section

In this section you can switch between input jacks A/B of the AD card with head amp (LMY2-ML).
1 INPUT [A]/[B] switches and LEDs
If an AD card with switchable input jacks A/B is
assigned to the channel, these switches select input
jack A or B.

DELAY section

In this section you can make settings for the internal delay function.
1 DELAY [ON] switch and LED
This switch turns the delay on/off for the selected
channel.
When on, the switch LED will light, and the input
signal will be delayed by the time shown in the
DELAY TIME [VALUE] indicator (2).
2 DELAY TIME encoder and [VALUE] indicator
The DELAY TIME encoder is used to adjust the delay
time of the selected channel.
At this time, the current delay time will be shown in
milliseconds in the DELAY TIME [VALUE] indica-
tor.
The delay time range is 0 msec – 250 msec.
Hint
It is convenient to use the input channel or ST IN
channel delay function to compensate for timing dif-
ferences between widely separated mics.
Even if the internal clock on which the PM1D system
operates is switched from 48 kHz to 44.1 kHz (or the
opposite), the delay time will not change. However
while a PM1D system is synchronized to a word
clock supplied from an external device, the displayed
time and the actual delay time may differ if the word
clock frequency is changed using vari-pitch.
22
1
A
B
INPUT
The LED for the currently selected input jack (A/B)
will light.
If another type of card is patched to the channel, the
LEDs will be dark.
1 2
The delay time can be adjusted independently for
each channel even for the two channels of a pair, or
for ST IN channels.
If you adjust the delay time here, decimal places
that are not subsequently displayed will be rounded
off.