Yamaha CS1D Operating Manual page 314

CS1D Reference Manual (Hardware)
2 MONITOR A DELAY [TIME] encoder and [VALUE]
indicator
The MONITOR A DELAY [TIME] encoder is used to
set the delay time of the delay that is built into the
MONITOR A output and the cue output.
The current delay time is shown by the DELAY TIME
[VALUE] indicator in millisecond units.
The delay time range is 0 msec – 750 msec.
3 MONITOR A DELAY [ON] switch and LED
This is an on/off switch for the internal delay of the
MONITOR A output.
The switch LED will light when this is on, and the
output signal will be delayed by the time displayed in
the MONITOR A DELAY TIME [VALUE] indicator
(2).
4 MONITOR A [LEVEL] volume
This is an analog volume that sets the MONITOR A
output level.
Hint
The value of this level cannot be stored in a scene or
controlled from outside (or by the internal software).
5 MONITOR A [L MONO]/[R MONO] switches and
LEDs
These switches select the stereo/monaural state of the
MONITOR A output. Depending on the lit/dark sta-
tus of each switch, the output signal of MONITOR A
will change as follows.
MONITOR A [L MONO]/[R MONO] switches
[L MONO] [R MONO]
MONITOR A output signal
switch switch
Dark Dark
Stereo signal
Lit Dark
Monaural signal of left channel
only
Dark Lit
Monaural signal of right channel
only
Lit Lit
Monaural signal of mixed left and
right channels
6 MONITOR A [ON] switch and LED
This is an on/off switch for the MONITOR A output.
The switch LED will light when this is on.
7 MONITOR A PHONES [LEVEL] volume
This is an analog volume that sets the output level of
the MONITOR A phones jack.
Hint
The value of this level cannot be stored in a scene or
controlled from outside (or by the internal software).
84