Table of Contents
Advertisement
Pulse-to-Tone
Xerox Document Centre 440/432/420 User Guide
Line 1
select this option if Line 1 is required.
Line 2
select this option if Line 2 is required.
NOTE: Only 1 telephone line is available on the DC420.
After selecting one of the above options, or if only one
telephone line is available, select Send or Receive to tell the
machine the type of job. Enter the phone number and select
Start .
The DC440/432/420 does not have a handset connected. It is
On-hook as indicated on the touch screen. If an external
telephone is connected, the machine will indicate Off-hook
when the handset is lifted from the telephone. If the recipient of
the fax does not have a dedicated telephone line, use manual
dialing.
Use the following options to dial a fax number manually:
Send
used to send a fax.
Mask Data
used to enter the fax number that contains confidential
numbers, for example a credit card number.
Receive
to receive a fax.
to switch between pulse and touch-tone dialing.
Valid pulse mode, or Dual Tone Multi-Frequency (DTMF),
dialing characters are numbers 1 through 9 and 0. Valid tone
mode characters are numbers 1 through 9, 0, * and #.
Dialing characters are different from the alphabet characters
on the dialingkeypad. They are available only through a special
character keypad. Select the special character keypad from
the touch screen.
Keypad
The keypad corresponds to the control panel telephone
keypad buttons. Select Keypad to use it instead of another
method.
Page 4-15
Advertisement
Table of Contents
