Show Bridge Stp - SMC Networks E21011 User Manual

| Spanning Tree Commands
C 23
HAPTER
port-priority (STP
Interface)

show bridge stp

E
XAMPLE
AP(stp-if-wireless 0: VAP[0])# path-cost 512
AP(stp-if-wireless 0: VAP[0])#
This command sets the spanning tree path cost for the VAP interface.
S
YNTAX
port-priority <priority>
priority - The priority for the VAP interface. (Range: 0-63)
C M
OMMAND ODE
Global Configuration (STP interface)
C U
OMMAND SAGE
This command defines the priority for the use of an interface in the
◆
Spanning Tree Protocol. If the path cost for all interfaces on a bridge
are the same, the interface with the highest priority (that is, lowest
value) will be configured as an active link in the spanning tree.
Where more than one interface is assigned the highest priority, the
◆
interface with lowest numeric identifier will be enabled.
E
XAMPLE
AP(stp-if-wireless 0: VAP[0])# port-priority 10
AP(stp-if-wireless 0: VAP[0])#
This command displays displays the global spanning tree settings for the
bridge.
S
YNTAX
show bridge stp
C M
OMMAND ODE
Exec
E
XAMPLE
AP#show bridge stp
Bridge STP Information
==================================
Bridge MAC : 00:12:CF:A2:54:30
Status : Disabled
priority : 32768
Hello Time : 2 seconds
Maximum Age : 20 seconds
Forward Delay : 15 seconds
– 188 –