SMC Networks E21011 User Manual page 133

Address Filtering
System Default : ALLOW addresses not found in filter table.
Filter Table
-----------------------------------------------------------
No Filter Entries.
Bootfile Information
===================================
Bootfile : ec-img.bin
===================================
Protocol Filter Information
===========================================================
Local Bridge :DISABLED
AP Management :ENABLED
Ethernet Type Filter :DISABLED
Enabled Protocol Filters
-----------------------------------------------------------
No protocol filters are enabled
===========================================================
Hardware Version Information
===========================================
Hardware version R01A
===========================================
Ethernet Interface Information
========================================
IP Address : 192.168.0.151
Subnet Mask : 255.255.255.0
Default Gateway : 192.168.0.1
Primary DNS : 210.200.211.225
Secondary DNS : 210.200.211.193
Speed-duplex : 100Base-TX Full Duplex
Admin status : Up
Operational status : Up
========================================
Wireless Interface 802.11a Information
===========================================================
----------------Identification-----------------------------
Description
SSID
Channel
Status
----------------802.11 Parameters--------------------------
Transmit Power
Data Rate
Fragmentation Threshold
RTS Threshold
Beacon Interval
DTIM Interval
Maximum Association
Native VLAN ID
----------------Security-----------------------------------
Closed System
Multicast cipher
Unicast cipher
WPA clients
WPA Key Mgmt Mode
WPA PSK Key Type
Encryption
Default Transmit Key
Static Keys :
– 133 –
| System Management Commands
C 13
HAPTER
: ALLOWED
: SMC 802.11a Access Point
: SMC_A 0
: 0 (AUTO)
: Disable
: 100% (5 dBm)
: 54Mbps
: 2346 bytes
: 2347 bytes
: 100 TUs
: 1 beacon
: 64 stations
: 1
: DISABLED
: WEP
: TKIP and AES
: REQUIRED
: PRE SHARED KEY
: ALPHANUMERIC
: DISABLED
: 1