Virtual Access Points (Vaps); Figure 44: Vap Settings - SMC Networks E21011 User Manual

V A P
IRTUAL CCESS
Aggregate MAC Protocol Data Unit (A-MPDU) — Enables / disables
◆
the sending of this four frame packet header for statistical purposes.
(Default: Enabled)
A-MPDU Length Limit (1024-65535) — Defines the A-MPDU length.
◆
(Default: 65535 bytes; Range: 1024-65535 bytes)
Aggregate MAC Service Data Unit (A-MSDU) — Enables / disables
◆
the sending of this four frame packet header for statistical purposes.
(Default: Enabled)
A-MSDU Length Limit (2290-4096) — Defines the A-MSDU length.
◆
(Default: 4096 bytes; Range: 2290-4096 bytes)
Set Radio — Sets all entered parameters.
◆
(VAP )
OINTS S
The access point supports up to eight virtual access point (VAP) interfaces
numbered 0 to 7. Each VAP functions as a separate access point, and can
be configured with its own Service Set Identification (SSID) and security
settings. However, most radio signal parameters apply to all eight VAP
interfaces.
The VAPs function similar to a VLAN, with each VAP mapped to its own
default VLAN ID. Traffic to specific VAPs can be segregated based on user
groups or application traffic. All VAPs can support up to a total of 64
wireless clients, whereby the clients associate with each VAP the same way
as they would with separate physical access points.
The radio channel settings for the access point are limited by local
N :
OTE
regulations, which determine the number of channels that are available.
See "Operating Channels" on page 250
maximum number channels available.

Figure 44: VAP Settings

for additional information on the
– 89 –
| Wireless Settings
C 8
HAPTER

Virtual Access Points (VAPs)