Snmp-Server Host - SMC Networks E21011 User Manual

C
◆
◆
E
R

snmp-server host

This command specifies the recipient of an SNMP notification. Use the no
snmp-server host
form to remove the specified host.
S
D
None
C
Global Configuration
C
◆
◆
E
R
snmp-server enable server
U
OMMAND SAGE
This command enables both authentication failure notifications and
link-up-down notifications.
The snmp-server host command specifies the host device that will
receive SNMP notifications.
XAMPLE
AP(config)#snmp-server enable server
AP(config)#
C
ELATED OMMANDS
YNTAX
snmp-server host <host_ip_address> <community-string>
no snmp-server host
host_ip_address - IP of the host (the targeted recipient).
community-string - Password-like community string sent with the
notification operation. (Maximum length: 23 characters)
S
EFAULT ETTING
M
OMMAND ODE
U
OMMAND SAGE
The snmp-server host command is used in conjunction with the
snmp-server enable server command to enable SNMP notifications.
You can configure up to four host IP addresses. A separate snmp-
server host command must be entered for each host.
Although you can set the community string using the snmp-server
host command by itself, it is recommended that you define this string
using the snmp-server community command prior to using the
snmp-server host command.
XAMPLE
AP(config)#snmp-server host 1 10.1.19.23 batman
AP(config)#
C
ELATED OMMANDS
– 151 –
| SNMP Commands
C 17
HAPTER