Table of Contents
Advertisement
Default Setting
128
Command Mode
Interface Configuration
Command Usage
• This command defines the priority for the use of a port in the Spanning Tree
Protocol. If the path cost for all ports on a wireless bridge are the same, the
port with the highest priority (that is, lowest value) will be configured as an
active link in the spanning tree.
• Where more than one port is assigned the highest priority, the port with lowest
numeric identifier will be enabled.
Example
Enterprise AP(if-wireless a)#bridge-link port-priority 1 64
Enterprise AP(if-wireless a)#
Related Commands
bridge-link path-cost (7-87)
show bridge stp
This command displays aging time and spanning tree settings for the Ethernet and
wireless interfaces.
Syntax
show bridge stp
Command Mode
Exec
Example
Enterprise AP#show bridge stp
Bridge MAC
Status
priority
designated-root
root-path-cost
root-Port-no
Hold Time
Hello Time
Maximum Age
Forward Delay
bridge Hello Time
bridge Maximum Age
bridge Forward Delay :
time-since-top-change: 89185 Seconds
topology-change-count: 0
Enterprise AP#
: 00:12:CF:05:B7:84
: Disabled
: 0
: priority = 0, MAC = 00:00:00:00:00:00
: 0
: 0
:
1 Seconds
:
2 Seconds
:
20 Seconds
:
15 Seconds
:
2 Seconds
:
20 Seconds
15 Seconds
Spanning Tree Commands
7
7-87
Advertisement
Table of Contents
