Wds Bridge Commands; Table 21: Wds Bridge Commands - SMC Networks E21011 User Manual

24
wds ap
wds sta
WDS B
RIDGE
The commands described in this section are used to set the operation
mode for each access point interface and configure Wireless Distribution
System (WDS) forwarding table settings.

Table 21: WDS Bridge Commands

Command Function
wds ap Selects the bridge operation mode for a radio
interface
wds sta Configures the MAC addresses of the parent
bridge node
show wds wireless Configures MAC addresses of connected child
bridge nodes
This command enables the bridge operation mode for the radio interface.
S
YNTAX
wds ap
D S
EFAULT ETTING
Disabled
C M
OMMAND ODE
Interface Configuration (Wireless) VAP
E
XAMPLE
AP(if-wireless 0 [VAP 0])#wds ap
AP(if-wireless 0 [VAP 0])#
This command configures WDS station mode on a VAP interface.
S
YNTAX
wds sta ap-ssid <ssid> address <mac-address>
ssid - Severice set identifier. Maximum: 32 characters.
mac-address - The MAC address of the connecting VAP in WDS-AP
mode.
– 193 –
C
OMMANDS
Mode Page
IC-W 193
VAP
IC-W 193
VAP
Exec 194